> Starts upon receipt of t320 or upon cell re- selection to E-UTRA from another RAT with validity time configured for dedicated priorities (in which case the remaining validity time is applied).
>stops upon selection of suitable E-UTRA cell OR a cell using another RAT >Starts while initiating RRC CONNECTION RE-ESTABLISHMENT procedure > At expiry, if security is not activated it goes to RRC IDLE else it initiates the CONNECTION RE-ESTABLISHMENT Procedure Upon initiating the CONNECTION RE-ESTABLISHMENT procedure When UE receives N311 consecutive in-sync INDs from lower layers/Ģ. >Starts when UE detects PHY layer related problems (when it receives N310 consecutive out-of-sync INDs from lower layers) > At expiry, Informs higher layers about barring alleviation >Stops when entering RRC_CONNECTED and when UE does cell re-selection >starts when access is barred while performing RRC CONNECTION ESTABLISHMENT for MO signaling In case of HANDOVER to E-UTRA, perform the actions defined as per the specifications applicable for the source RAT. In the case of CELL CHANGE ORDER from E-UTRA OR intra E-UTRA handover, initiate the RRC connection re-establishment procedure.Ģ. >At expiry, it performs action based on need.ġ. >Stops at the successful completion of HANDOVER to EUTRA or CELL CHANGE ORDER is met
>Starts at the Receipt of RRC CONNECTION RECONFIGURATION message along with Mobility Control Info OR at the receipt of mobility from EUTRA command message including CELL CHANGE ORDER >At expiry, Informs higher layers about barring alleviation >Stops while entering RRC_CONNECTED and upon cell re-selection mode >Starts when access is barred while performing RRC CONNECTION ESTABLISHMENT for MO(Mobile Originating) calls When selected cell becomes unsuitable to continue further RRC Connection Re-Establishment REJECT message OR >Stops at the Receipt of RRC Connection Re-establishment OR >Starts at the RRC Connection Re-establishment REQUEST >Stops at the Receipt of RRC connection setup or reject message OR at the cell reselection time OR upon abortion of connection establishment by Higher layers (L2/元). >Starts at the RRC connection REQ transmit